Can I use the same ground for my 5V battery and Arduino like this

I have been powering my Arduino with an external 5V battery for a couple of days thru the vin and ground. I want to add a breadboard for testing some stuff. I usually have my MKR NB 1500 connected to a USB port when using a breadboard. Then I would just connect the 5V pin to the breadboard plus lane, and the ground pin to the minus lane. But my external battery cant access the ground pin I was to this now. So I was wondering if I could share the same ground lane between the battery and the Ardu

DIY Arduino Power Supply Shield with 3.3v, 5v and 12v Output Options

Arduino nano breaks when using a common 12 volt power supply. - Microcontrollers - Arduino Forum

servo - Do external battery packs need to connect to ground on the arduino? - Arduino Stack Exchange

Can I drive a two relay module directly from Arduino - Project Guidance - Arduino Forum

Powering Arduino Through 5V - General Electronics - Arduino Forum

How to Power Up Arduino Uno : 4 Steps - Instructables

Common ground between arduino and 12V circuit - General Electronics - Arduino Forum

How to Power Arduino Nano and Pro Mini with 5.14V Power Bank - Project Guidance - Arduino Forum

How to power Arduino Uno from an L298N motor driver's 5V terminal - Quora

Is there any way to connect a power bank with arduino uno? - Quora

Ground Rails in Schematics - fritzing forum

Home Automation - How to Add Relays to Arduino : 10 Steps - Instructables

Newb power question with Neopixels : r/arduino

How do I wire multiple LEDS to one Ground connector? Help Needed please - Project Guidance - Arduino Forum

Arduino Power Supply Module for Sensors 12v, 5v, and 3.3 volts