Support pour pile CR2032 ADA1870 Adafruit - Connectique

Sewable CR2032 Battery Holder : ID 653 : $1.95 : Adafruit

2x Support pile 2032 - Cr2032 - 3 pins - a souder - vertical - Q&J

2x Support pile 2032 - Cr2032 - 3 pins - a souder - vertical - Q&J

This is a coin cell holder for the common CR2032 type battery The feet of the holder have a small hole that allow it to be sewn without modification

Adafruit Sewable CR2032 Battery Holder

Adafruit Industries 2x2032 Coin Cell Battery Holder - 6V output

Adafruit 2 x 2032 Coin Cell Battery Holder - 6V output

This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes in the metal connection tabs, just large enough for a #5 or smaller needle to pass through. One tab connects to common ground (negative) and the other tab is +3 Volts. This holder is meant to be used with Lithium CR2032 (20mm diameter, 3.2mm thick) sized coin batteries. These are almost always 3V at about 200+ mAh capacity.

Adafruit Industries ADA653 Sewable CR2032 Battery Holder

Pile au lithium éco CR2032 Camélion - Piles lithium

This adorable little coin cell battery holder is great for small, portable, or wearable projects. It holds two 20mm coin cell batteries (also known as