MODULE 1 RELAIS ARDUINO

Relais Module 5v voor Arduino - Otronic

DIYables Relay 5V 1-Channel for Arduino, ESP32, ESP8266, Raspberry Pi

Question about using a 5V relais with Arduino UNO - General Electronics - Arduino Forum

DIYables Relay 5V 1-Channel for Arduino, ESP32, ESP8266, Raspberry Pi

A normal style relay to switch a single data line to turn on/off. Perfect for RaspberryPi or Aduino projects. You need 5v to power the relay coil.

Relay for Raspberry Pi or Arduino 1-Channel 5V Relay Module 250V/10A

A normal style relay to switch a single data line to turn on/off. Perfect for RaspberryPi or Aduino projects. You need 5v to power the relay coil.

Relay for Raspberry Pi or Arduino 1-Channel 5V Relay Module 250V/10A

1, The module uses genuine quality relay , normally open interfaces Maximum load : AC 250V/10A, DC 30V/10A; 2, Using SMD optocoupler isolation ,

One 1 Channel 12V Relay Module Board Shield with Optocoupler Support High and Low Level Trigger Power Supply Module for Arduino

1 Channel 5V Relay Module with High/Low Level Trigger – Konnected

The module complies with international safety standards, the control area and the load region isolation trench. With the power supply and relay

1 Channel Relay Module Interface Board Shield for Arduino 5V Low Level Trigger One PIC AVR DSP ARM MCU DC AC 220V

How to Set Up a 5V Relay on the Arduino - Circuit Basics