Ferrite Mix Selection - Palomar Engineers®

RFI Kits — FlexRadio Community

Ferrite Mix Selection - Palomar Engineers®

Multi-Ratio Transformers

Put a bunch of these ferrite beads on everything I plug into my truck and finally found electrical silence on 2m! : r/amateurradio

Ferrite Beads, Common Mode Chokes, RFI--Jim W6LG--Ham Radio Basics--A Look At Palomar-Engineers.com

Suppresses radio frequency interference (common mode noise carried on coax shield) ¨ Shielded cable protection ¨ Highly Effective Inductive Ferrite

RFI Suppressor for F Connector Cables - Simple in line filtering with male/female extension, Select AM Broadcast or Ham Band Filter Range

Simple Jumper Feed Line Choke Optimized for 14-30 MHz The, simplest, most cost effective feed line choke is a ferrite ring installed as shown in the

Coax Jumper Choke - RG-8X - RFI Range: 14-30 MHz, -40 dB Noise Reduction, Yagi, Log Periodic, CB Antennas

Ferrite Snap On RF Choke/Isolator - 1/4/6mm cable, RG-58/59/06/LMR240 - 3-300 M

FERRITES - Antenna Products - Palomar Engineers®

Ferrite Ring Combo Pack, FT140 - .9 ID, 6 Rings - Mix 43, 61, 77, RFI Range .1-2000 MHz - Antenna Products - Palomar Engineers®

All Slip On Ferrite Beads - Slip On Ferrite Beads - Palomar Engineers®

Ferrite Core Products - Palomar Engineers®

Palomar Engineers Kenwood TS-480SAT Transceiver RFI Kit - 8 RFI/Noise Reduction

5000 Watt rated 1:1 CUBE™ BALUN * Help keep RF out of the shack. * Provides maximum transfer of RF to the antenna. * Suppress radiation from the

CUBE 1:1 Feed Line Choke Balun, 5KW, 1.8-61 MHz, -38dB Common Mode Rejection, Eyebolts/Top Studs Options