Engine Flush Plus by LIQUI MOLY – LM Performance

PRODUCT DESCRIPTION Combination of active agents made up of special additives and carrier fluid. Brings all types of oilsoluble and oil-insoluble residues into suspension and removes these from the oil circuit during the next oil change. Following this, the engine that has been cleared of deposits and contaminants and
PRODUCT DESCRIPTION Combination of active agents made up of special additives and carrier fluid. Brings all types of oilsoluble and oil-insoluble residues into suspension and removes these from the oil circuit during the next oil change. Following this, the engine that has been cleared of deposits and contaminants and the fresh oil can then deliver its full performance. Highly effective cleaning fluid for clearing the engine interior of troublesome deposits. Dissolves sludge and lacquer formers quickly and reliably. All types of oil-soluble and oil-insoluble residues are brought into suspension and removed during the next oil change. An engine which has been cleaned of deposits and contamination and which is then filled with fresh oil not contaminated with old impurities can develop its full performance characteristics. Wear in the engine is thus reduced and the service life is extended. PRODUCT DETAIL For cleaning and flushing out the oil circuits of gasoline and diesel engines. 300 ml sufficient for up to 6 l of motor oil. Can be safely used in vehicles with timing belt running in oil. Not suitable for use on motorbikes with wet clutches! PROPERTIESgentle cleaning - rapid cleaning - does not attack common sealing materials - minimizes wear - simple to use without disassembly - optimal engine performance - highly economical - tested for particulate filters and catalytic converters - tested for turbochargerTECHNICAL DATAColor / appearance yellow, brown Base additive, carrier liquid Flash point 63 °C DIN ISO 2592 Pour point -45 °C DIN ISO 3016 Form liquid Viscosity at 40 °C <7 mm²/s Odor characteristic AREAS OF APPLICATION For cleaning and flushing out the oil circuits in gasoline and diesel engines. Use at each oil change. Can be safely used in vehicles with toothed belt running in oil. Not suitable for use in motorcycles with wet clutches! APPLICATION 300 ml sufficient for up to 6 l of oil. Add to the motor oil at operating temperature before the oil change. Then allow engine to idle for approx. 10 minutes. Then change the oil and the filter. Compatible with commercially available motor oils.