Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum

I received the PETG Basic Lake Blue filament on 12 July and immediately installed it in my AMS then kicked off a print using all the default Bambu Studio settings. The print had tons of stringing. I then dried the filament at 65C, re-calibrated my P1P, and set the K factor for the filament only to have the print fail again. I even slowed down from 200mm/s outer wall to 60mm/s without success. I have had no issues printing the same part using esun brand PETG. Has anyone else had issues with the

Light flood for closed Bambu lab printers by Jorge Rui - MakerWorld

Bamby Labs Petg Basic Fail - Troubleshooting - Bambu Lab Community Forum

Whats wrong with my printer? Petg filament Overture. : r/BambuLab

Unable to get BambuLab PETG Basic to print well at 0.08mm height - Filament - Bambu Lab Community Forum

What is causing this ugly thing (PETG)? - Troubleshooting - Bambu Lab Community Forum

AMS filament type and color selection issue · Issue #1744 · bambulab/BambuStudio · GitHub

Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum

Trouble printing PETG from Bambu Lab - Bambu Filament and Accesories - Bambu Lab Community Forum

Print has voids and gouges - Troubleshooting - Bambu Lab Community Forum

Bambu PETG Basic Print Failures - Filament - Bambu Lab Community Forum

Print has voids and gouges - Troubleshooting - Bambu Lab Community Forum

PETG will not print in my X1 - Bambu Lab X1 Series - Bambu Lab Community Forum

Unable to get BambuLab PETG Basic to print well at 0.08mm height - Filament - Bambu Lab Community Forum

Unable to get BambuLab PETG Basic to print well at 0.08mm height - Filament - Bambu Lab Community Forum

Bambu Lab X1 Carbon: Info & Discussion (SRO) - Esk8 Electronics - esk8.news: DIY Electric Skateboard Forums